Skip to content
PenBlitz
← Help

Troubleshooting

The usual problems and what to do about them.

“No paper fed”

The feed rollers could not grab a sheet. Refill the paper or fan the stack, push it in as far as it goes, remove scraps from the paper path and print again.

The machine does not start printing

  • Is a sheet from the last print still in the machine? Take it out.
  • Is paper loaded and pushed in fully?
  • If the machine writes on the roller instead of pulling a sheet, switch on “Feed before every sheet” in the “Printer” tab.

“Printer unreachable”

  • Is the machine switched on and in the same Wi-Fi as the Mac?
  • Its address may have changed: click “Find printer” in the “Printer” tab.
  • If Wi-Fi keeps failing, connect the machine by USB cable.

A QR code cannot be scanned

  • Enter the real line width of your pen in the “Printer” tab.
  • Make the squares larger; the QR block offers the smallest size that works.
  • Check the link itself: it must begin with https:// or http://.

The print is shifted or the wrong size

Print the calibration page and enter scale and offset as described under “First print and calibration”.

The connection was lost during a print

Over Wi-Fi the machine prints from its own memory and usually finishes the sheet on its own. The job is marked as failed because PenBlitz could not watch the end; check the sheet and print the remaining ones.